#
# Configuration file for your misdn hardware
#
# Usage: /etc/init.d/misdn-init start|stop|restart|config|scan|help
#

#
# Card Settings
#
# Syntax: card=<number>,<type>[,<option>...]
#
#    <number>   count your cards beginning with 1
#    <type>     either 0x1,0x4 or 0x8 for your hfcmulti hardware,
#               or the name of your card driver module.
#    <option>	ulaw       - uLaw (instead of aLaw)
#               dtmf       - snable DTMF detection on all B-channels
#               pcm_slave  - set PCM bus into slave mode
#
card=1,0x1
card=2,0x8

#
# Port settings
#
# Syntax: <port_type>=<port_number>[,<port_number>...]
#
#    <port_type>    te_ptp   - TE-Mode, PTP
#                   te_ptmp  - TE-Mode, PTMP
#                   nt_ptp   - NT-Mode, PTP
#                   nt_ptmp  - NT-Mode, PTMP
#    <port_number>  port that should be considered
#
te_ptmp=1,2,3,4,5,6,7,8,9

#
# Port Options
#
# Syntax: option=<port_number>,<option>[,<option>...]
#
#    <option>  master_clock  - use master clock for this S/T interface
#                              (only once per chip, only for HFC 8/4)
#              optical       - opticalv (only HFC-E1)
#              los           - report LOS (only HFC-E1)
#              ais           - report AIS (only HFC-E1)
#              slip          - report SLIP (only HFC-E1)
#
#option=1,master_clock
#option=2,ais
#option=3,optical,los,ais,slip

#
# General Options for your hfcmulti hardware
#
# poll=<number>
#
#        Only one poll value must be given for all cards.
#        Give the number of samples for each fifo process.
#        By default 128 is used. Decrease to reduce delay, increase to
#        reduce cpu load. If unsure, don't mess with it!
#        Valid is 8, 16, 32, 64, 128, 256.
#
# pcm=<number>
#        
#        Give the id of the PCM bus. All PCM busses with the same ID
#        are expected to be connected and have equal slots.
#        Only one chip of the PCM bus must be master, the others slave.
#        -1 means no support of PCM bus.
#
# debug=<number>
#
#        Enable debugging (see hfc_multi.h for debug options).
#
poll=64
#pcm=1
debug=0
